TM 9-2350-261-20-1
R E P L A C E E X H A U S T P I P E S
DESCRIPTION
This task covers:
Remove (page 7-16).
Install (page 7-17).
INITIAL SETUP
Tools:
General Mechanics Tool Kit (Item 30, App D)
Socket Wrench Set (Item 88, App D)
Socket Wrench Set (Item 89, App D)
Torque Wrench (Item 95, App D)
Torque Wrench (Item 99, App D)
Personnel Required:
Unit Mechanic
References:
see your -10
Equipment Conditions:
Engine stopped/shutdown (see your -10)
Carrier blocked (see your -10)
Trim vane lowered (see your -10)
Power plant front access door open
(see your -10)
Air cleaner housing and element removed
(page 7-7)
R E M O V E
1.
W A R N I N G
Do not touch hot exhaust
pipes with bare hands. you
could get a bad burn.
N O T E
Muffler clamps are used on early exhaust
system only. If muffler clamp has to be
replaced, new exhaust pipes will need to
be ordered.
Step 1 is for the early system. Step 2 is for
the current system.
Loosen two manifold clamps (1) and two
muffler joint clamps (2).
2.
3.
4.
Loosen two manifold clamps (1).
Remove exhaust pipes (3 and 4) from engine
manifolds (5 and 6) and muffler joint (7).
Separate exhaust pipe (3) from exhaust
pipe (4).
7-16
