R E P A I R A I R C O N T R O L V A L V E ..CONT.

R E P A I R A I R C O N T R O L V A L V E

R E P L A C E A I R C O N T R O L V A L V E C A B LE

TM-9-2350-261-20-1 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
818

TM 9-2350-261-20-1 8. Remove locknut (1), three cables (4) and housing (6). Discard I N S T A L L 9. 10. 11. 12. 13. 14. 15. 16. screw (2), clamp bracket (5) from locknut. Install bracket (5) and three cables (4) on (3), housing (6). Secure with clamp (3), screw (2), and new locknut (1). Secure pin (7) to baffle (8) with new cotter pin (9) and washer (10). Secure hinge (11) to baffle (8) with two screws (12), washers (13), and new locknuts (14) . Install baffle (8) and hinge (11) in housing (6). Secure with two screws (15), washers (16), and nuts (17). With cable in full forward position and baffle in down position, support housing (6) and secure cable (18) to pin (7) with two collars (19) and setscrews (20). Secure cable (18) and two clamps (21) to weldnut (22) with washer (23), screw (25), and new locknut (24). Secure housing (6), new gasket (26), and screen (27) to driver’s compartment bulkhead with three screws (28) and washers (29). Secure plate (30), housing (6), and new gasket (26) to driver’s compartment bulkhead with five screws (31), washers (32), and two spacers (33). FOLLOW-THROUGH STEPS 1. 2. 3. Install air cleaner Install air cleaner (page 7-7). hose (page 7-3). 4. element and housing 5. Install driver’s power plant access panel 6. (page 24-25). 7. Close power plant from access panel door (see your -10). Raise trim vane (see your -10). Start engine (see your -10). Check air control valve for proper operation. Engine stopped/shutdown (see your -10). END OF TASK 7-12

Privacy Statement
Press Release
Contact