R E P L A C E F U E L F I L T E R M O U N T I N G B R A C K E T

R E P L A C E F U E L F I L T E R E L E M E N T S ...CONT.

R E P L A C E F U E L F I L T E R M O U N T I N G B R A C K E T ....CONT.

TM-9-2350-261-20-1 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
795

TM 9-2350-261-20-1 R E P L A C E F U E L F I L T E R M O U N T I N G B R A C K E T INITIAL SETUP Tools General Mechanics Tool Kit (Item 30, App D) Torque Wrench (Item 96, App D) Materials/Parts Antiseize compound (Item 4, App C) Lockwasher (4) Personnel Required Unit Mechanic References see your -lo Equipment Condition Engine stopped/shutdown (see YOUr -10) Carrier blocked (see your -10) Battery ground lead disconnected (pages 13-2) Power plant rear access panel removed (page 24-27 or 24-29) Primary fuel falter assembly removed (page 6-123) Secondary fuel falter assembly removed (page 6-125) Generator mounting bracket removed (100 amp only) (page 9-31) or (200 amp only) (page 9-34) REMOVE 1. Remove four screws (1), Iockwashers (2), and fuel filter mounting bracket (3) from engine. Discard lockwashers. N O T E The 200 amp fuel filter mounting bracket is different from the 100 amp fuel filter mounting bracket INSTALL 2. 3. 4. Apply antiseize compound to threads of four screws (1). Secure bracket (3) to engine with four screws (1) and new lockwashers (2). Tighten four (6&75 N^.m ) Screws (1) to 50-55 lb-ft torque. Use torque wrench. 6-130

Privacy Statement
Press Release
Contact