50.51.Connect ramp hydraulic line at coupling (1)(all except M741A1).Connect ramp hydraulic line at coupling (2)(all except M741A1).52. Install clamp (3), on radiator inlet tube (4).Secure clamp to hanger (5) with washer (6),screw (7), and nut (8).NOTEScrews and washers must be clean, dry,and free of lubricants and paint. If yourcarrier is equipped with 6C universaljoints, screws are 3/8-24 x 1-3/4; ifequipped with 7C universal joints, screwsare 1/20 x 2.53. Connect propeller shaft (9) to transmissionwith four new flat washers (10) and fournew screws (11). Use torque wrench(Item 96) and adapter to tighten screws. On6C universal joints, tighten to 35-40 lb-ft(47-54 N•m) torque, and on 7C joints,tighten to 83-100 lb-ft (113-136 N•m)torque, then loosen screws and tighten themto the correct torque again. See page 2-29for correct readings on torque wrenches withadapters.54. Install L&R final drive propeller shafts(page 20-5 and 20-7).ITM 9-2350-261-20-1 5-20
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business