10. Loosen two setscrews (1) that secures fuel
cutoff control cable (2) to governor arm
pin (3).
13.
14.
TM 9-2350-261-20-1
Remove four screws (13) and flat washers
(14). Separate propeller shaft (15) from yoke
(16) on transmission. Discard screws and
washers.
Remove L&R final drive propeller shafts
(page 20-5 and 20-7).
15. Remove nut (17), washer (18), screw (19),
clamp (20), and radiator inlet tube (21)
from hanger (22).
11. Remove nut (4), screw (5), washer (6), and
clamps (7) from engine cylinder head cover
bracket (8).
12. Remove screw (9) and nut (10). Pull cable
(11) through clamp (12).
16. Disconnect ramp hydraulic line at cou-
pling (23).
GO TO NEXT PAGE
Change 4
5-13
