TM 9-2350-261-20-1
INSTALL
6.
7.
8.
9.
10.
11.
Install collector can bracket (1) on
transmission case. Secure with two screws
(2) and new tab washers (3). Tighten
screws (2) to 252-800 lb-in (28-34 N•m)
torque. Loosen screws and retighten to
above torque. Use torque wrench and socket
set.
Install clean element (4) in collector can (6).
Install collector can (5) on bracket (l).
Secure with retainer (6), two washers (7),
and wing nuts (8). Stake top threads of
retainer studs after installing wing nuts (8).
Install two drain hoses (9 and 10) in collec-
tor can bracket (1).
Install breather hose (11) in collector can
bracket (1). Secure with screw (12), clamp
(13), and nut (14).
Install breather hose (11) on engine and on
power plant disconnect bracket. Secure with
two clamps (15), clamp (16), washer (17),
nut (18), and two screws (19).
1. Install power plant rear access panel
2. Install driver’s power plant access panel
(page 24-27 or 24-29).
(page 24-25).
END OF TASK
4-12
FOLLOW - THROUGH- STEPS
