R E P L A C E E N G I N E O I L F I L T E R E L E M E N T A N D P A R T S ...CONT.

R E P L A C E E N G I N E O I L F I L T E R E L E M E N T A N D P A R T S

R E P L A C E E N G I N E O I L F I L T E R A S S E M B L Y

TM-9-2350-261-20-1 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
619

TM 9-2350-261-20-1 INSTALL NOTE If only filter element is being replaced do steps 10, 13, 14, 15, 16, 21, and 22 only. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. Apply a thin coat of engine oil on new gasket (l). Install gasket in falter head (2). Install new gasket (3) on housing (4). Install bolt (5) in housing (4). Install washer (6), spring (7), new preformed packing (8), and retainer (9) on bolt (5). Secure with nut (10). Place new filter element (11) very carefully over bolt (5) in housing (4). Install housing (4) with new element (11) on head (2). Install drain plug (12) in housing (4). Tighten bolt (5) to 50-60 lb-ft (68-81 N•m) torque. Use torque wrench. Apply a thin coat of sealing compound to cleaned external threads of plug (14) and bushing (13). If removed, install plug (14) in head (2). Install bushing (13) in head (2). (15) in bushing (13). WARNING Carbon Monoxide is poison- ous and can kill you. Do not idle engine with driver’s power plant access panel off unless there is VERY GOOD AIR FLOW. 21. 22. Start engine (see your -10). Check for oil leaks. Stop engine (see your -10). Wait about 20 minutes for oil to drain back to pan, then check engine oil level. Add oil if needed (see your LO). FOLLOW-THROUGH STEPS 1. Install driver’s power plant access panel (page 24-25). END OF TASK Install valve 4-4

Privacy Statement
Press Release
Contact