TM 9-2350-261-20-1
NOTE
CAUTION
If a prompting message Po-1 appears on
the display, refer to substeps 2c for Po-1
and 2d for Po-2.
To prevent damage to equipment, allow
engine to idle for at least two minutes
after running power test.
If prompting message Po-1 does not ap-
pear on the display, go to substep m.
o. A number will be displayed after engine
has returned to idle speed. This number is
the test result in units of percent of
nominal rated power.
g.
h.
j.
k.
l .
Wait for prompting message Po-1 to
appear on display.
Set TEST SELECT switches to Po-1
value.
Press and release TEST button.
Wait for prompting message Po-2 to
appear on display.
Set TEST SELECT switches to Po-2
value.
m. Press and release TEST button.
n. When CIP is displayed, sharply depress
accelerator. Hold it to the floor. When
VTM displays OFF, release accelerator.
4. Return to troubleshooting.
% Power Minimum Test Limit
Altitude
Vehicle
2000 ft to
Above
0-2000 ft 4000 ft
4000 ft
M113 FOV
75%
66%
60%
END OF TASK
3-286
Change 4