TM 9-2350-261-20-1STE/ICE-R TEST 13 POWER (PERCENT)INITIAL SETUPTools:STE/ICE-R Test Set (Item 71.1, App D)Personnel Required:Unit MechanicReferences:See your -10If VID has been performed during powerhookup procedures (page 3-275) go tostep 2. If not, continue with step 1.NOTECAUTIONEngine governor speed must be checkedbefore performing power test. If governorspeed is not within limits specified forvehicle/equipment, notify direct supportmaintenance.1. Enter VID.a. Set TEST SELECT switches to 60.b. Press and release TEST button.c. Wait for prompting message UEH to ap-pear on display.Do not run power test if governor speed isnot within specified limits. Damage toengine may result.d. Observe displayed value (rpm).d. Set TEST SELECT switches to 03.e. Press and release TEST button.f. Wait for VTM to display and hold VIDnumber.3. Perform power test.2. Start and idle engine.a. Set TEST SELECT switches to 10.b. Press and release TEST button.a. Set TEST SELECT switches to 13.b. Press and release TEST button.c. Wait for prompting message UEH to ap-pear on display. If UEH does not appearon display, go to substep g.d. Set TEST SELECT switches to 03.e. Press and release TEST button.NOTENOTEEngine idle speed must be checked beforeperforming power test. If idle speed is notwithin limits specified forvehicle/equipment, adjust idle speed tobe within proper limits.The number just entered will remain onthe display only a few seconds.f. Wait for VTM to display the VTD justentered.Do not run power test if idle speed cannotbe properly adjusted.c. Observe displayed value (rpm) and adjustEquipment Conditions:Engine stopped (see your -10)Carrier blocked (see your -10)STE/ICE-R power hooked up (page 3-275)STE/ICE-R engine RPM test hooked up(page 3-277)Warm engine to operating temperature(see your -10)idle speed if necessary.GO TO NEXT PAGEChange 43-285
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
