S T E / I C E - R S T A R T E R C I R C U I T T R O U B L E S H O O T I N G CONT.

S T E / I C E - R S T A R T E R C I R C U I T T R O U B L E S H O O T I N G

S T E / I C E - R S T A R T E R C I R C U I T T R O U B L E S H O O T I N G ....... CONT.

TM-9-2350-261-20-1 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
580

TM 9-2350-261-20-1 1. Is starter circuit resistance within 5 to 27? Y ES 1. Check batteries to make sure they are fully charged (TM 9-6140-200-14). 2. Verify no faults found. 1. Is E013 displayed? NO Y ES 1. Check batteries to make sure they are fully charged (TM 9-6140-200-14). 2. Verify no faults found. I 1. Crank engine (see your-10). 2. Does any message appear other than GO? 1. Is this the third time E013 was displayed? NO YES 1. Repeat this part of trouble- shooting. 4 k 1. Turnoff all electrical equipment. NO 1. Go to offset fault isolation 2. Set test select switches to 90. (TM9-4910-571-12-&P). 3. Press and hold test until CAL appears on display. 2. Verify no faults found. 4. Is offset value within limits of -225 to +225? I Y ES 1. Press and release test button. NO 1. Check batteries 2. Crank engine for a few seconds with fuel off. 3. Is starter current above 100 amps? (TM 9-6140-200-14). 2. Verify no faults found. \ 3-260 Change 1

Privacy Statement
Press Release
Contact