TM 9-2350-261-20-1
1. Turn MASTER POWER switch to OFF
(see your -10 and TM 11-7010-256-12&P).
2. Remove ten screws (1) and lockwashers (2), and lower
faceplate (3). Discard lockwashers.
3. Turn ON AC RIGHT OUTLETS circuit breakers CB8
(4) and CB9 (5).
4. Measure resistance between terminals 1 and 2 (6) of
circuit breakers CB8 (4) and CB9 (5).
5. Does multimeter read 0 ohms for each measurement?
1. Raise faceplate (1) and secure to Power Control Enclo-
sure with ten new lockwashers (2) and screws (3).
2. Go to: No Power To AC Circuits (page 3-226.97).
NOTE
Resistance in CB8 and CB9
should be 0 ohms. If any
resistance
is
present,
replace that CB.
1. Replace circuit breaker CB8
and/or CB9 (page 40.1-33).
2. Verify no faults found.
3-226.30
Change 3
