TM 9-2350-261-20-1
1.
2.
3.
4.
5.
Turn MASTER POWER switch to OFF
(see your -10 and TM 11-7010-256-12&P).
Remove ten screws (1) and lockwashers (2), and lower
faceplate (3). Discard lockwashers.
Turn ON AC LEFT OUTLETS circuit breakers CB6 (4)
and CB7 (5).
Measure resistance between terminals 1 and 2 (6) of
circuit breakers CB6 (4) and CB7 (5).
Does multimeter read 0 ohms for each measurement?
1. Raise faceplate (1) and secure to Power Control Enclo-
sure with ten new Iockwashers (2) and screws (3).
2. Go to: No Power To AC Circuits (page 3-226.97).
NOTE
Resistance in CB6 and CB7
should be 0 ohms. If any
resistance is
present,
replace that CB.
1. Replace circuit breaker CB6
and/or CB7 (page 40.1-33).
2. Verify no faults found.
3-226.26
Change 3