NO DC POWER FROM TENT INTERFACE PANEL A5 ... CONT.

NO DC POWER FROM TENT INTERFACE PANEL A5 ... CONT. - TM-9-2350-261-20-1_456

NO POWER FROM ROADSIDE AC POWER EXTENSION BOX A6

TM-9-2350-261-20-1 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
427

TM 9-2350-261-20-1 1. Turn MASTER SWITCH to OFF (see your -10). 2. Remove ten screws (1) and lockwashers (2) and lower faceplate (3). Discard lockwashers. 3. Set DC TENT INTERFACE panel circuit breaker to ON (see TM 11-7010-256-12&P). 4. Measure resistance between terminals (4) of circuit breaker CB16 (5). 5. Does multimeter read 0 ohms? 1. Raise faceplate (1) and secure to Power Control Enclo- sure with ten new lockwashers (2) and screws (3). 2. Go to: Power Control Enclosure DC Input/Output Inoperative (page 3-226.1). 1. Replace circuit breaker CB16 (page 40.1-33). 2. Verify no faults found. Change 3 3-226.22

Privacy Statement
Press Release
Contact