T R A N S M I S S I O N O I L H I T E M P I N D I C A T O R M A L F U N C T I O N S ....CONT.

T R A N S M I S S I O N O I L H I T E M P I N D I C A T O R M A L F U N C T I O N S ....CONT. - TM-9-2350-261-20-1_366

D I F F E R E N T I A L O I L H I T E M P I N D I C A T O R M A L F U N C T I O N S

TM-9-2350-261-20-1 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
337

TM 9-2350-261-20-1 1. 2. 3. 4. Turn MASTER SWITCH to OFF. Remove front main harness circuit 327/27G plug (1) from TRANS OIL HI TEMP assembly jack (2). Measure resistance between front main harness circuit 327/27G (1) circuit 327 pin and ground. Does multimeter read more than 0 ohms? 1. Install TRANS OIL HI TEMP indicator cover lens, gasket, bulb, and gasket. 2. Remove engine harness plug (1) from front main harness jack (2) at earner bulkhead. 3. Measure resistance between engine harness plug (1) pin G (3) and ground. 4. Does multimeter read more than O ohms? 1. Install front main harness circuit 327/27G plug on trans oil hi temp indicator. 2. Repair engine harness circuit 327 (page 14-3). 3. Verify no faults found. 1. Remove jumper cable and install circuit 327 plug on trans oil hi temp switch. 2. Replace TRANS OIL HI TEMP indicator assembly (page 11-22). 3. Verify no faults found. 1. Remove jumper wire and install engine harness circuit 327 plug on trans oil hi temp switch. 2. Repair front main harness circuit 327 (page 14-3). 3. Verify no faults found. 3-158

Privacy Statement
Press Release
Contact