TM 9-2350-261-20-1
T R A N S M I S S I O N O I L H I T E M P I N D I C A T O R M A L F U N C T I O N S
INITIAL SETUP
Tools:
General Mechanics Tool Kit (Item 30, App D)
Digital Multimeter (Item 43, App D)
Jumper Wire
Personnel Required:
Unit Mechanic
References:
See your -10
Equipment Conditions:
Engine stopped/shutdown (see your -10)
Carrier blocked (see your -10)
Engine and transmission cooled down
Trim vane lowered (see your -10)
Power plant front access door open
(see your -10)
Drivers power plant access panel removed
(see your -10)
Power plant rear access panels removed
(see your -10)
1. Remove TRANS OIL HI TEMP indicator cover lens
(1), gasket (2), bulb (3), and gasket (4.
2. Measure resistance between bulb center contact (5)
and bulb base (6).
3. Does multimeter read 0-5 ohms?
1. Replace TRANS OIL HI
TEMP indicator bulb
(page 11-22).
2. Verify no faults found.
GO TO NEXT PAGE
3-153