TM 9-2350-247-20-3
REPLACE WINCH PROPELLER SHAFT (M548A1) — Continued
0412 00
INSTALLATION
1.
Place assembled propeller shaft (1) between yoke (2) on power takeoff (3) and yoke (4) on transfer gearcase (5).
2.
Place two clamps (6) over yoke (2). Secure each clamp with two new lock washers (7) and two nuts (8). Tighten nuts to
14-17 lb-ft (19-23 N•m) torque.
3.
Place two clamps (6) over yoke (4). Secure each clamp with two new lock washers (7) and nuts (8). Tighten nuts to
14-17 lb-ft (19-23 N•m) torque.
FOLLOW-THROUGH STEPS
1.
Install cab center floor plate (WP 0394 00).
2.
Install air cleaner container with element (WP 0152 00).
3.
Install left grille (WP 0390 00).
4.
Lower center seat (see your -10).
5.
Connect battery negative lead (WP 0292 00).
END OF TASK
0412 00-5/6 blank
