TM 9-2350-247-20-3
REPLACE WINCH PROPELLER SHAFT (M548A1) Continued
0412 00
ASSEMBLY
1.
Place new seal (1) into cap (2). Place cap and seal on yoke (3).
CAUTION
Make sure yoke (4) and yoke (3) are installed with bearing journals in the same plane. Make
sure assembled shaft is not twisted. Propeller shaft can be damaged during operation if yokes
are not installed right.
2.
Install yoke (3) into sleeve yoke (4).
3.
Install cap (2) on sleeve yoke (4).
4.
Install one journal-and-bearing assembly (5) in yoke (3). Install two retaining rings (6) to hold assembly in yoke.
5.
Install one journal-and-bearing assembly (5) into sleeve yoke (4). Install two retaining rings (6) to hold assembly in
sleeve yoke.
6.
Install one grease fitting (7) in front and rear journal-and-bearing assemblies (5) and one grease fitting in sleeve yoke (4).
7.
Lubricate two journal-and-bearing assemblies (5) with grease.
0412 00-4