TM 9-2350-247-20-2
REPLACE RIGHT FINAL DRIVE SHAFT (M548A1) -- Continued
0334 00
NOTE
Some universal joints do not have lubrication fittings.
4.
Remove four lubrication fittings (8) from two universal joints (4) if needed.
INSTALLATION
NOTE
Some universal joints do not have lubrication fittings.
1.
If removed, install four lubrication fittings (1) in two universal joints (2).
2.
Install yoke (3) in final drive (4).
NOTE
Use 5/32 inch (4 mm) thick, hardened steel flat washers only.
These are 6C universal joints only.
3.
Install two universal joints (2), one on yoke (3) and the other on differential (5). Secure with eight new screws (6) and
flat washers (7).
4.
Place shaft (8) on two universal joints (2). Secure with eight new screws (6) and flat washers (7).