TM 9-2350-247-20-2
REPLACE LEFT FINAL DRIVE SHAFT (M548A1)
THIS WORK PACKAGE COVERS:
Removal (page 0333 00-1).
Installation (page 0333 00-2).
INITIAL SETUP:
Maintenance Level
References
Unit
See your -10
Tools and Special Tools
General Mechanic's Tool Kit (WP 0541 00, Item 57)
Torque Wrench (WP 0541 00, Item 68)
Equipment Condition
Materials/Parts
Engine stopped (see your -10)
Screw (16)
Carrier blocked (see your -10)
Personnel Required
Left center floor plates removed (WP 0394 00)
Unit Mechanic
REMOVAL
1.
Remove eight screws (1), flat washers (2), and connector (3) from two universal joints (4). Discard screws.
2.
Remove eight screws (1), flat washers (2), and two universal joints (4) from yoke (5) and differential (6). Discard screws.
3.
Remove yoke (5) from final drive (7).
NOTE
Some universal joints do not have lubrication fittings.
4.
Remove four lubrication fittings (8) from two universal joints (4) if needed.
