TM 9-2350-247-20-2
REPLACE LEFT FINAL DRIVE SHAFT (M548A1) -- Continued
0333 00
INSTALLATION
NOTE
Some universal joints do not have lubrication fittings.
1.
If removed, install four lubrication fittings (1) in two universal joints (2).
2.
Install yoke (3) in final drive (4).
NOTE
Use 5/32 inch (4 mm) thick, hardened steel flat washers only.
These are 6C universal joints only.
3.
Install two universal joints (2), one on yoke (3) and the other on differential (5). Secure with eight new screws (6) and
flat washers (7).
4.
Place connector (8) on two universal joints (2). Secure with eight new screws (6) and flat washers (7).
5.
Tighten 16 screws (6) to 35-40 lb-ft (47-54 Nm) torque. Loosen and retighten screws to
35-40 lb-ft (47-54 Nm) torque.
FOLLOW-THROUGH STEPS
1.
Lube two universal joints (WP 0128 00).
2.
Install left center floor plates (WP 0394 00).
3.
Road test carrier (WP 0128 00) to check left final drive shaft for proper operation.
END OF TASK
