TM 9-2350-247-20-2
REPAIR WIRING HARNESS -- Continued
0294 00
NOTE
Unit Maintenance can only repair multipin plugs with up to three sockets. For plugs with more
than three sockets, notify your supervisor.
4.
Remove multiple connectors the same way as single connectors. Be sure to tag leads to ensure correct installation. See
Removal Procedure Step 1 and Step 2.
NOTE
For wiring harness repair, it may be necessary to remove Y-adapters and dummy plugs.
5.
Remove Y-type adapter or dummy plug from harness lead.
a.
Pull harness leads (8) from Y-type adapter (9). Remove adapter.
b.
Pull dummy plug (10) from male or female connector (11).
INSTALLATION
CAUTION
Crimping lower part of pin may damage pin and it will not hold lead. Crimp only middle part
of contact pin with correct size die.
Install female connector on harness lead.
NOTE
If replacing lead, cut new wire from bulk supply. Measure original length, gauge, and type of
wire.
1.
Install male connector on harness lead.