TM 9-2350-247-20-2
REPAIR WIRING HARNESS -- Continued
0294 00
a.
Strip insulation from lead (1) to uncover just enough wire to fill contact pin well.
b.
Slide shell (2) and washer (3), if removed, over lead (1).
c.
Insert lead (1) into new pin (4) and crimp.
d.
If removed, place slotted washer (5) on lead (1) under pin (4) and pull shell (2) over washer (3) or washer (5) and
pin.
2.
Install female connector on harness lead.
a.
Strip insulation from lead (6) to uncover just enough wire to fill contact socket well.
b.
Slide shell (7) and sleeve (8) over lead (6).
c.
Insert lead (6) in new socket (9) and crimp or solder.
d.
Slide sleeve (8) and shell (7) over socket (9).
3.
Install terminal connector on harness lead.
a.
If nipple (10) was removed from lead (11), strip insulation from lead to uncover just enough wire to fill terminal
well. Slide nipple over lead.
b.
If insulated sleeving (12) was removed from lead (13), slide new insulated sleeving on lead. Strip insulation from
lead to same length as crimp (14) on terminal (15).
0294 00-4
