TM 9-2350-287-20-1
7-62. INTANK FUEL PUMPS AND SYSTEM RELAY LEAD ASSEMBLY (12353646), LEAD
ASSEMBLY (12353647), AND Y-CONNECTOR REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
l Battery ground cables disconnected
General mechanic’s tool kit (Item 24,
(para 7-41).
Appendix I)
l Driver's portable instrument panel removed
(para 7-6).
Equipment Conditions:
l Vehicle parked on level ground (refer to
TM 9-2350-287-10).
a.
1.
2.
3.
4.
b.
1.
2.
3.
4.
REMOVAL
Disconnect connector (1) from intank fuel pumps and system
relay (2).
Disconnect lead 415B (7) from wiring hamess connector415B
(6).
Disconnect lead No. 76 (9) from y-connector (8). Disconnect
lead No. 10(12) from y-connector (5).
Remove wire connector 415 (3) of lead assembly 12353647
from y-connector (5). Remove wire connector 10E (4) of cable
assembly 12376405 from y-connector (5), and remove y-
connector (5). Remove connector 415 (3) from circuit breaker
No. 6 (10) on circuit breaker panel No. 1 (11).
Connect connector 415 (3) on circuit breaker No. 6 (10) on
circuit breaker panel No. 1 (11). Connect wire connector 10E
(4) of cable assembly 12376405 to y-connector (5). Connect
wire connector 415 (3) of lead assembly 12353647 to y-
connector (5).
Connect lead No. 10(12) toy-connector (5). Connect lead No.
76 (9) to y-connector (8).
Connect lead 415B (7) to wiring harness connector 415B (6).
Connect connector (1) to relay (2).
FOLLOW-ON MAINTENANCE:
Install driver’s portable instrument panel (para 7-6).
Connect battery ground cables (para 7-41).
7-193
INSTALLATION
