b. DISASSEMBLY - TM-9-2350-287-20-1

7-64. ACCESSORY CONTROL BOX TO AIR CLEANER BLOWER MOTORS, PERSONNEL HEATER WIRING HARNESS (12351544) REPAIR

FOLLOW-ON MAINTENANCE - TM-9-2350-287-20-1_896

TM-9-2350-287-20-1 Carrier Ammunition Tracked M992A21 (2350-01-352-3021) EIC:AE6 Manual
Page Navigation
867

TM 9-2350-287-20-1 7-64. ACCESSORY CONTROL BOX TO AIR CLEANER BLOWER MOTORS, PERSONNEL HEATER WIRING HARNESS (12351 544) REPAIR (continued). 6. 7. 8 9. b. 1. 2. 3. c. 1. 2. d. 1. 2. Disconnect hamess connector 402A (23) from personnel heater fuel pump (24). Disconnect harness plug (19) from personnel heater (22). Disconnect two hamess connectors 415 (20) from connectors on air cleaner blower motors (21). Remove two screws (12), washers (13), Iockwashers (14), and straps (11) and wiring harness 12351544 (18) from vehicle. Discard Iockwashers. Replace hardware after harness removal. DISASSEMBLY NOTE Remove electrical insulation tape only from section of wiring harness to be disassembled. Remove electrical insulation tape from section of wiring harness. Separate and isolate wiring harness branches. Disassemble each wiring hamess branch and replace defective wires. ASSEMBLY Reassemble each wiring harness branch. Regroup wiring harness branches and secure with electrical insulation tape. INSTALLATION Install wiring harness 12351544 (18) in vehicle with straps (11), screws (12), new Iockwashers (1 4), and washers (1 3). Connect two harness connectors 415 (20) to connectors on air cleaner blower motors (21). 7-197

Privacy Statement
Press Release
Contact