TM 9-2350-287-20-1
2-28. LUBRICATION INSTRUCTIONS.
Apply a light coat of Iubricating oil to metal parts after they are cleaned, but before they are assembled, to prevent
corrosion. Lubricate components and systems in accordance with the instructions in Appendix G.
2-29. TORQUE VALUES.
Torque values given in the procedures apply to unlubricated threads. Follow the torque values given in the
maintenance procedures. If no torque value is given, follow the Torque Value Guide in Appendix C.
2-30. DECAL REPLACEMENT.
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothing, and DO NOT use near open flame or excessive heat.
NOTE
For proper installation of decal, note its location before removing.
1.
Use drycleaning solvent to loosen damaged decal, and remove decal from surface. Discard decal.
2.
Clean any decal residue from surface with dry cleaning solvent. Wipe surface with clean rag.
NOTE
Surface must be clean and dry before installing new decal.
3.
Remove protective backing from new decal and position on surface.
4.
Using a dry rag, press decal into position. Start in the center of decal and press outward to remove any air
bubbles.
2-438
