TM 9-2350-287-20-1
2-22. SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION
ENGINES (STE/lCE) (continued).
b. STE/ICE TROUBLESHOOTING - (continued).
(5) STARTER NEGATIVE CABLE DROP - TEST 69.
Tools/Test Equipment:
• General mechanic’s tool kit (Item 24, Appendix I)
• STE/lCE test set (Item 65, Appendix I)
A.
1. Connect DCA cable W1 connector P1 to VTM
connector J1.
2. Connect DCA cable W1 to harness 12329996
connector at DCA receptacle in driver’s com-
partment.
3. Push power switch on VTM to ON position.
4. Do confidence test 66/99 (para 2-22.a(1)).
5. Dial 60 into TEST SELECT.
6. Press and release TEST button. Message
“VEH” should be displayed on the VTM.
7. Enter the vehicle ID number 11.
8. Enter 69 into TEST SELECT.
9. Press and release TEST button.
10. Crank engine while holding fuel shutoff
control handle out (refer to TM 9-2350-287-10).
11. Record test results and check limits on VTM.
Are results higher than 12 vdc?
Do test 91 on cable. If cable is
bad, repair or replace wiring
harness 12329994 (para 7-75).
Verify problem is solved.
Fault does not exist as indicated.
Recheck fault symptom.
END OF TASK
2-413
