TM 9-2350-287-20-12-22. SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTIONENGINES (STE/ICE) (continued).b. STE/lCE TROUBLESHOOTING - (continued).(2) STARTER CIRCUIT RESISTANCE - TEST 74.Tools/Test Equipment:l General mechanic’s tool kit (Item 24, Appendix I)STE/lCE test set (Item 65, Appendix I)A.1. Connect DCA cable W1 connector P1 toVTM connector J1.2. Connect DCA cable W1 to harness12329996 connector at DCA receptale indriver’s compartment.3. Push power switch on VTM to ON position.4. Do confidence test 66/99 (para 2-22.a(1)).5. Dial 60 into TEST SELECT.6. Press and release TEST button. Message“VEH” should be displayed on the VTM.7. Enter the vehicle ID number 11.8. Enter 74 into TEST SELECT, then pressTEST until “CAL” appears.9. Release TEST button and wait for reading.Reading should be between -225 to +225.10. Press and release TEST button.11. When “GO” shows on the VTM display,crank engine while holding fuel shutoff controlhandle (refer to TM 9-2350-287-10).12. When VTM shows “OFF", stop crankingengine.13. Record test results and check limits onVTM.Are results between 3 and 25 milliohms?Fault does not exist as indicated.Recheck fault symptom.Do test 67 (para 2-22.b(8), test 68 (para2-22.b(19), test 69 (para 2-22.b(5), andtest 70 (para 2-22.b(16). If tests aregood, replace starter motor (para 7-5).Verify problem is solved.END OF TASK2-410
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
