TM 9-2350-287-20-1
2-19. TROUBLESHOOTING CHART (continued).
k. TRANSMISSION AND DRIVING CONTROLS
(1) TRANSMISSION OVERHEATS, TRANSMISSION
(continued).
OIL TEMPERATURE GAGE READS OVER 285°F
(140°C). MASTER WARNING LIGHT IS LIT.
Initial Setup:
Tools/Test Equipment:
Personnel Required: Two
General mechanic’s tool kit (Item 24,
Appendix 1)
Equipment Conditions:
Transmission access doors open
Materials/Parts:
(refer to TM 9-2350-287-10).
Lockwasher (3) (Item 183, Appendix H)
WARNING
l Transmission contains hot oil
under high pressure. Stop engine
before removing or installing
transmission components. Failure
to follow these precautions can
cause injury to personnel or
damage to equipment.
A. Inspect transmission oil cooler lines for leaks
or restrictions.
Are transmission oil cooler lines free of leaks and
restrictions?
Tighten leaking transmission oil cooler
lines. Repair or replace restricted lines
(para 8-5). Verify problem is solved.
B. 1. Remove three screws, washers, and
Iockwashers, transmission oil filter cover, and
transmission oil filter. Discard Iockwashers.
2. Check for clogged, dirty, or improperly in-
stalled oil filter.
Is transmission oil filter clean and installed properly?
Continued on next page
2-217
