TM 9-2350-287-10OPERATING THE CONVEYOR (continued)WARNINGIf operating with upper rear door open, always engage mechanicalsafety lock before beginning conveyor operations. This will preventupper rear door from dropping If hydraulic system fails.16. If operating with upper rear door (9) open, lower or raise upper rear door (9) to either 45 degrees or 90 degrees fromclosed position. This will engage mechanical safety lock.Raise door slightly until lock and lock stop are about 1/8 inch apart.17. Release rubber end-section latch (17) at each end of conveyor. Flip out forward and rear dead-end sections (3 and18).NOTEEach conveyor end section can bepositioned at one oftwo angles respective to angle of conveyor), using flipperplates under each end section.18. Adjust forward or rear dead-end section (3 or 17) as necessary, using flipper plates (19).2-155
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business