TM 9-2350-287-10
OPERATING THE CONVEYOR (continued)
4.
Open upper rear door (ballistic shield) to 45-
degree position (p. 2-138). Make sure locking
device is engaged.
5. Remove two slings (6) from hook (5) on
hydraulic actuator base (4).
WARNING
l Make sure you attach slings
to conveyor properly, or
conveyor may drop.
l Have an assistant hold
conveyor in stowed position
as you release stowage strap.
This will prevent conveyor
from slipping from stowed
position, causing serious
injury to you or others.
l Keep all parts of your body
clear of conveyor hinges.
NOTE
If conveyor needs to be deployed parallel
to the ground, use short legs of two
slings. If conveyor needs to be lower,
use long legs of two slings.
6.
Connect two slings (6) to both sides of conveyor
(2).
7.
Remove two quick-release pins (7) from two
conveyor support struts (8).
8. Have an assistant restrain conveyor (2) in
stowed position by supporting it at forward
dead-end section (3). Make sure two slings
(6) are properly attached toconveyor (2) then
release conveyor (2) from stowage strap (1).
2 - 1 5 1
