TM 9-2350-287-10OPERATING THE CONVEYOR (continued)11. To stabilize two conveyor center hinges (12), pull forward on red handle (10) and place loop (13) over hook (11).Push back on red handle (10) to lock handle (10) in place.12. Position upper rear door (9) so conveyor (2) reaches desired height.13. Install two quick-release pins (7) in two conveyor support struts (8). Tighten two friction clamps (14).14. Lower upper rear door (9), and remove two slings (6) from both sides of conveyor (2) and stow in hook (5) onhydraulic actuator base (4).WARNINGSlings are not intended tosupport conveyor under normaloperating conditions. ONLY ifconveyor support strut ismissing or fails may slings beused to support conveyorduring operation. Whenoperating in this mode, avoidsudden movement of conveyor.Periodically inspect slings andattaching hardware for damage.Notify Unit maintenanceImmediately upon missioncompletion if sling damageexists.2-153
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business