TM 9-2350-277-20-5
REPLACE COOLANT HEATER EXHAUST ELBOW AND PIPES — Continued
0724 00
WARNING
Older gaskets are made out of asbestos. Handle with care. Discard older gasket properly as a
hazardous material per local standard operating procedure.
2.
Remove four screws (5), washers (6), upper pipe (2), and gasket (7) from exhaust grill housing. Discard gasket.
3.
Remove upper pipe (2) from lower pipe (3). Remove lower pipe from elbow (4).
4.
Remove elbow (4) from coolant heater.
INSTALLATION
1.
Place clamp (1) on elbow (4). Install elbow on coolant heater. Tighten clamp.
2.
Place clamp (1) on lower pipe (3). Install pipe in elbow (4). Tighten clamp.
3.
Place clamp (1) on upper pipe (2). Install upper pipe in lower pipe (3). Tighten clamp.
0724 00-2
