REPLACE RAMP CYLINDER BREATHER HOSE (ALL EXCEPT M1064A3)

FOLLOW-THROUGH STEPS - TM-9-2350-277-20-5_168

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
120

TM 9-2350-277-20-5 REPLACE RAMP CYLINDER BREATHER HOSE (ALL EXCEPT M1064A3) 0666 00 THIS WORK PACKAGE COVERS: Removal (page 0666 00-1). Installation (page 0666 00-3). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Materials/Parts Sealing compound (WP 0928 00, Item 56) Locknut Lockwasher (3) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Rear floor plate removed (WP 0539 00) REMOVAL 1. Remove three screws (1), lockwashers (2), and clamps (3) from hull and bulkhead weldnuts. Discard lockwashers. 2. Remove screw (4), washer (5), locknut (6), and two clamps (7)(8) from bilge pump pipe (9) and breather hose (10). Discard locknut. 0666 00-1

Privacy Statement
Press Release
Contact