INSTALLATION - TM-9-2350-277-20-5

REPLACE RAMP CYLINDER BREATHER HOSE (M1064A3 ONLY)

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
122

TM 9-2350-277-20-5 REPLACE RAMP CYLINDER BREATHER HOSE (ALL EXCEPT M1064A3) — Continued 0666 00 INSTALLATION 1. Apply light coat of sealing compound to threads of adapter (11). Install adapter in ramp cylinder (12). 2. Install hose (10) on adapter (11). 3. Install clamp (7) on bilge pump pipe (9) and clamp (8) on breather hose (10). Secure with screw (4), washer (5), and new locknut (6). 4. Install three clamps (3) on hose (10). Align clamps with bulkhead and hull weldnuts. Secure with three new lockwashers (2) and screws (1). FOLLOW-THROUGH STEPS 1. Install rear floor plate (WP 0539 00). 2. Start engine (see your -10). 3. Raise and lock ramp (see your -10). 4. Stop engine (see your -10). END OF TASK 0666 00-3/4 blank

Privacy Statement
Press Release
Contact