TM 9-2350-277-20-5REPLACE WIRE ROPE AND PULLEYS (M1064A3 ONLY) — Continued 0658 00INSTALLATION1. Route wire rope (3) through pulley mount.2. Align three pulleys (6) with pulley mount. Secure with three headed pins (5) and new cotter pins (4).3. Align wire rope swedged eye with ramp mount bracket. Secure with headed pin (2) and new cotter pin (1).FOLLOW-THROUGH STEPS1. Connect wire rope to ramp cylinder (WP 0656 00).2. Install rear floor plate (WP 0543 00).3. Start engine (see your -10).4. Raise and lower ramp several times (see your -10). Check to see that wire rope and pulleys operate properly.5. Raise and lock ramp (see your -10).6. Stop engine (see your -10).END OF TASK0658 00-2
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
