INSTALLATION - TM-9-2350-277-20-5

REPLACE WIRE ROPE AND PULLEYS (ALL EXCEPT M1064A3)

REPLACE WIRE ROPE AND PULLEYS (M1064A3 ONLY)

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
89

TM 9-2350-277-20-5 REPLACE WIRE ROPE AND PULLEYS (ALL EXCEPT M1064A3) — Continued 0657 00 INSTALLATION 1. Route wire rope (6) through pulley mount. 2. Align two pulleys (9) with pulley mount. Secure with two headed pins (8) and new cotter pins (7). 3. Align wire rope end fitting with ramp mount bracket. Secure with headed pin (5) and new cotter pin (4). 4. Align guard (3) and two washers (2) with upper pulley mount. Secure with pin (1). FOLLOW-THROUGH STEPS 1. Connect wire rope to ramp cylinder (WP 0656 00). 2. Install rear floor plate (WP 0539 00). 3. Raise ramp (see your -10). Check that wire rope and pulleys work right. 4. Stop engine (see your -10). END OF TASK 0657 00-2

Privacy Statement
Press Release
Contact