TM 9-2350-277-20-4
REPLACE TRIPOD STOWAGE BRACKETS (M901A3 ONLY) — Continued
0592 00
7.
Remove two cotter pins (1), support pivot pin (2), spring (3), spacer (4), and spring (5) from tripod tiedown support (6)
and tripod tiedown arm (7). Remove tripod tiedown arm from tripod tiedown support. Discard cotter pins.
8.
Remove two screws (8), lockwashers (9), and washers (10) from tripod tiedown support (6). Remove tripod tiedown
support from hull. Discard lockwashers.
INSTALLATION
1.
Install tiedown support (6) on hull. Secure with two washers (10), new lockwashers (9), and screws (8).
2.
TIGHTEN TWO SCREWS (8) TO 216-264 LB-IN (24-30 N m) TORQUE.
3.
Install tripod tiedown arm (7) on tiedown support (6). Secure with spring (5), spacer (4), spring (3), pivot support pin (2),
and two new cotter pins (1).
NOTE
Short end of springs touch tripod tiedown support and long ends touch grooved slot of tripod
tiedown arm.
4.
Install tripod tiedown cap (11) on tripod tiedown arm (7). Secure with two washers (12), cap pivot pin (13), and two new
cotter pins (14).
0592 00-3
