ASSEMBLY - TM-9-2350-277-20-4

DISASSEMBLY (cont) - TM-9-2350-277-20-4_666

ASSEMBLY (cont) - TM-9-2350-277-20-4_668

TM-9-2350-277-20-4 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
557

TM 9-2350-277-20-4 REPLACE/REPAIR RADIO OPERATOR’S SEAT (M981A3, M1068A3, AND M58 ONLY) — Continued 0568 00 5. Install support plate (5), eight washers (8), four screws (6), and new locknuts (7) on tube (9). TIGHTEN SCREWS TO 80-90 IN-LB (9.0–10.1 N m) TORQUE. 6. Install rack (4), two washers (3), screws (2), and new locknuts (1) on support plate (5). 7. If removed, install new bushing (1) in seat (2). Peen both ends snugly to seat and secure. 8. Install two new long spring pins (3) in seat (2). NOTE If handle (4) is replaced, use latch (5) as a template, and drill 1/8 inch (3 mm) hole in handle for spring pin (6). 9. Install latch (5), spring (7), and handle (4) in seat (2). Secure with two new short spring pins (6). 10. If locknut(s) (8) was removed, install new locknut(s) (8) in seat (2). 11. Secure seat (2) to rails (9) with eight screws (10). 12. Align backrest bracket (11) and two spacers (12) with two rails (9). Secure with two new lockwashers (13) and screws (14). 13. Align two clips (15) and bracket (11) with seat (2). Secure with six screws (16), washers (17), and new locknuts (18). 14. Install seat cushion (19) on seat (2). 15. Install back brace (20) in bracket (11). 0568 00-5

Privacy Statement
Press Release
Contact