TM 9-2350-277-20-4
REPLACE CUSHIONING PADS
0570 00
THIS WORK PACKAGE COVERS:
Removal (page 0570 00-1).
Installation (page 0570 00-1).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Materials/Parts
Adhesive (WP 0928 00, Item 4)
Cleaning Compound (WP 0928 00, Item 17)
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
REMOVAL
NOTE
Cushioning pads are used at various stowage locations (pioneer tools, tow cables, etc.). All pads
are replaced the same way. Replace only cut, torn, or hard pads.
1.
Using putty knife or similar tool, lift corner of cushioning pad and peel pad from hull.
2.
Scrape any remaining adhesive from hull.
INSTALLATION
1.
Thoroughly clean hull mating surface with cleaning compound.
2.
Apply thin coat of adhesive to hull mating surface and back of new pad.
3.
Allow 10 to 20 minutes for adhesive to dry. Surface should be tacky, but not too sticky. Warmer temperature will speed
drying time.
4.
Position pad on hull and press firmly into place.
END OF TASK
0570 00-1/2 blank
