TM 9-2350-277-20-4
REPLACE PERSONNEL SEATS, BACKRESTS, CUSHIONS, AND BELTS
(M1059A3 ONLY)
0549 00
THIS WORK PACKAGE COVERS:
Removal (page 0549 00-1).
Installation (page 0549 00-3).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Materials/Parts
Cotter pin, per seat (8)
Locknut, per seat (2)
Locknut, per seatbelt (2)
Rivet, per strap
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Ramp lowered (see your -10)
REMOVAL
NOTE
There are two personnel seats and two backrests in the M1059A3 vehicle. Remove and install
the seats and backrests in the same way.
1.
Remove two locknuts (1), screws (2), and backrest (3) from sponson brackets. Discard locknuts.
2.
Remove four cotter pins (4), washers (5), two straight pins (6), and seat (7) from sponson brackets. Discard cotter pins.
3.
Remove four cotter pins (8), two straight pins (9), and two legs (10) from seat (7). Discard cotter pins.
4.
Remove two locknuts (11), washers (12), screws (13), and seatbelt (14) from each position on seat (7). Discard locknuts.
5.
Remove two straps (15) and cushion (16) from seat (7).
0549 00-1
