TM 9-2350-277-20-4ADJUST RAMP LOCK (M113A3, M901A3, M981A3, AND M1059A3 ONLY) — Continued 0521 0011. Push handle (13) in full forward position. Push bracket (3) to the rear until forward edge of slot in bracket makes contactwith cam surface on latch (1).12. Tighten two screws (2).13. The latch (1) should point down as shown in illustration. Put your hand under latch and try to lift latch. If adjustment isright, latch will not move.14. Move handle (13) to full released position. Latch (1) will contact rear edge of bolt in bracket (3) and will move up asshown in illustration.15. Wipe chalk off ramp surface and repeat seal test (Step 1).16. If ramp fails test, check and repeat Steps 1 - 14, as needed.END OF TASK0521 00-5/6 blank
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
