TM 9-2350-277-20-4
REPLACE RAMP DOOR HANDLES AND SHAFT — Continued
0519 00
ADJUSTMENT
NOTE
When adjusted right, door handle will have no end play. Ramp door should be flush with ramp
in the closed position.
1.
Remove handles (1) and (2) from ramp (3) (Steps 2 - 5).
2.
Remove or install washer(s) (4) and (5) on shaft of handle (1) from inside and outside ramp (3) to obtain proper fit.
NOTE
Install washer(s) (4) on inside and washer(s) (5) on outside of ramp up to a maximum of nine at
each position.
3.
Install handles (1) and (2) on ramp (Steps 1 - 4).
4.
Repeat steps as often as needed to obtain right adjustment.
FOLLOW-THROUGH STEPS
1.
Open and close ramp door to check that ramp door handles are installed right.
2.
Perform chalk test (WP 0155 00page 5c).
END OF TASK
0519 00-3/4 blank
