TM 9-2350-277-20-4REPLACE COMMANDER’S HATCH COVER (M577A3 AND M1068A3 ONLY) — Continued 0503 00INSTALLATION1. If removed, place seal (1) over retaining groove on cover (2). Press seal into place. Trim end of seal, if necessary.2. Install screw (3) in cover (2). Secure with new locknut (4).3. Align cover (2) with hinge brackets. Install two spacers (5) and tubes (6).4. Apply a light coat of grease on each spring (7). Install 14 springs in each tube (6).5. Place cover (2) in vertical position. Install two retaining plates (8) on hatch brackets. Secure with four screws (9) andnew locknuts (10).FOLLOW-THROUGH STEPS1. Install and adjust commander’s hatch interior latch WP 0502 00.2. Close cover and check for proper installation.END OF TASK0503 00-3/4 blank
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business