TM 9-2350-277-20-3
REPLACE TRANSMISSION RANGE CONTROLLER/BRACKET (USED WITH
CABLE-ACTIVATED STEERING LOCK) — Continued
0387 00
INSTALLATION
1.
Install bracket (1) on bulkhead. Secure with three screws (2), six washers (3), and three new locknuts (4).
2.
Connect wiring harness (5) to controller (6).
3.
Install four mounts (7) on bracket (1). Secure with four screws (8), new lockwashers (9), and washers (10).
4.
Install controller (6) on four mounts (7). Secure with four screws (11), new lockwashers (12), and washers (13).
NOTE
Do not tighten jamnuts until all parts to the cable and mechanical steering lock are fully
assembled and adjusted.
5.
Remove nut (14) from push-pull assembly (15) and insert end of push-pull assembly into hole in bracket (16). Secure
with nut (14) and new lockwasher (17).
6.
Secure end of push-pull assembly (15) to controller arm (18) with pin (19), two washers (20), and new cotter pin (21).
0387 00-3
