TM 9-2350-277-20-3
REPLACE TRANSMISSION RANGE CONTROLLER/BRACKET (USED WITH
CABLE-ACTIVATED STEERING LOCK) — Continued
0387 00
2.
Remove nut (6) and lockwasher (7) from end of push-pull assembly (4), and remove push-pull assembly from bracket
(8). Reinstall nut (6) on push-pull assembly (4) for future use. Discard lockwasher.
3.
Remove four screws (9), lockwashers (10), washers (11), and controller (12) from four mounts (13). Discard
lockwashers.
4.
Remove four screws (14), lockwashers (15), washers (16), and mounts (13) from bracket (17). Discard lockwashers.
NOTE
Install covers on disconnected electrical cable connectors and components during maintenance.
Use tape, cloth, cardboard, or any appropriate material to prevent damage to components.
5.
Disconnect wiring harness (18) from controller (12).
6.
Remove three screws (19), six washers (20), three locknuts (21), and bracket (17) from bulkhead. Discard locknuts.
0387 00-2
