TM 9-2350-277-20-3
REPLACE WARNING PANEL LIGHTS — Continued
0294 00
INSTALLATION
CAUTION
Make sure circuit leads are connected to correct lights. See wiring diagrams at the end of this
manual.
1.
If removed, install light assembly (1).
a.
Place light assembly (1) on rear of warning light panel. Secure with two new lockwashers (2) and screws (3).
b.
Connect circuit lead (4) to light assembly (1).
2.
Install light bulb (5).
a.
Install gasket (6) and light bulb (5) in light assembly (1). Push and turn light bulb to the right to secure.
b.
Install gasket (7) and lens (8) in light assembly (1). Turn lens to the right to secure.
FOLLOW-THROUGH STEPS
1.
Connect battery ground strap (WP 0337 00), (WP 0338 00), or (WP 0339 00).
2.
Turn MASTER SWITCH to ON (see your -10).
3.
Check warning panel lights as follows (see your -10):
a.
ENGINE COOLANT LOW LEVEL light should be off. It will come on when you ground circuit 352 lead.
b.
TRANS OIL HI TEMP indicator should be off. It will come on when you ground circuit lead 327.
c.
ENGINE OIL LOW PRESS indicator should be on.
d.
STEERING LOCKED indicator should be on when transmission controller is in SL.
4.
Turn MASTER SWITCH to OFF (see your -10).
END OF TASK
0294 00-3/4 blank
