TM 9-2350-277-20-2
REPLACE GLOW PLUG CONTROLLER MOUNTING BRACKET Continued
0212 00
INSTALLATION
1.
Install mounting bracket (1), two spacers (2), washers (3), new lockwashers (4), and long screws (5) on front of engine.
TIGHTEN SCREWS TO 192-240 LB-IN (22-27 N m) TORQUE. USE TORQUE WRENCH.
2.
Install two washers (6), new lockwashers (7), and short screws (8) into front of mounting bracket (1). TIGHTEN
SCREWS TO 46-50 LB-FT (62-68 N m) TORQUE. USE TORQUE WRENCH.
3.
Install glow plug controller (9), four washers (10), two new lockwashers (11), bolts (12), and nuts (13) on mounting
bracket (1).
FOLLOW-THROUGH STEPS
1.
Connect battery ground strap (WP 0337 00), (WP 0338 00), or (WP 0339 00).
2.
Install engine access panel (see your -10).
END OF TASK
0212 00-2