NO DC POWER FROM TENT INTERFACE PANEL A5 (M1068A3 ONLY)Continued

NO DC POWER FROM TENT INTERFACE PANEL A5 (M1068A3 ONLY)Continued - TM-9-2350-277-20-1_451

NO POWER FROM ROADSIDE AC POWER EXTENSION BOX A6 (M1068A3 ONLY

TM-9-2350-277-20-1 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
343

TM 9-2350-277-20-1 NO DC POWER FROM TENT INTERFACE PANEL A5 (M1068A3 ONLY)—Continued 0092 00 BY 1. Turn MASTER SWITCH to OFF (see your -10). 2. Remove ten screws (1) and lockwashers (2) and lower faceplate (3). Discard lockwashers. 3. Set DC TENT INTERFACE panel circuit breaker to ON TM 11-7010-256-12&P. 4. Measure resistance between terminals (4) of circuit breaker CB16 (5). 5. Does multimeter read 0 ohms? YES NO BYN 1. Replace circuit breaker CB16 (WP 0827 00). 2. Verify no faults found. B2Y 1. Raise faceplate and secure to Power Control Enclosure with ten new lockwashers and screws. 2. Go to: Power Control Enclosure A1 DC Input/Output Inoperative (M1068A3 Only) (WP 0090 00). 0092 00-4

Privacy Statement
Press Release
Contact