FUEL TANK PAD: REMOVAL AND INSTALLATION (CONTINUED)

RETAINING STRAP AND CHANNEL GROUP REPAIR

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
70

FUEL TANK PAD: REMOVAL AND INSTALLATION (CONTINUED) CAUTION Avoid damaging fuel tanks when removing fuel tank pads. A B C D E F NOTE All fuel tanks are not constructed the same. If the side retaining strap fits flush against the lower fuel tank when installed, a pad is not re- quired. If a space exists between the tank and re- taining strap, a pad is required. D Remove fuel tank pads (3). INSTALLATION Clean pad mounting surfaces thoroughly to remove all residue from old pad and adhesives. Remove all paint from hull mounting surface. Apply adhesive (item 4, Appx B) to pad and mounting surface and let dry until tacky. Install hull-mounted pads. Install rear retaining strap pad (1) and channel pad (2). (See in- stallation steps A-C.) B Remove rear retaining strap pad (1) if required. See page 4-24 Trim fuel tank pads (3) to proper thickness for alinement and for removal of retaining strap. shim of fuel tanks. C Remove channel pad (2) if required. See page 4-24 for removal Install fuel tank pads (3). (See installation steps A-C.) of channel. TA312516 4-23 Change 1 TM 9-2350-267-34

Privacy Statement
Press Release
Contact