FUEL TANK REPAIR (CONTINUED) - TM-9-2350-267-34

FUEL TANK REPAIR (CONTINUED) - TM-9-2350-267-34_82

FUEL TANK REPAIR (CONTINUED) - TM-9-2350-267-34_84

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
65

FUEL TANK REPAIR (CONTINUED) NOTE If damaged area is near an opening in tank, apply a backing plate with masking tape and release film, rather than wire cloth. E Cut and trim a piece of wire screen slightly larger than open- ing. If opening is less than 1 inch across at greatest point, wire screen is not required. F Cut glass cloth patches to size and shape. Cut first patch 1/2 inch larger than screen and each succeeding patch 1/2 inch larger until sufficient cloth has been built up to level patched area with surrounding tank wall (usually 6 or 7 patches). G Mix resin and hardener as directed on can label. H Thoroughly saturate scarfed area and wire screen with cement and apply screen over opening. I Remove about 1/5 of cement from mixing container. To this, fold in small amount of regenerated silica to obtain putty-like consistency. Use the mixture to apply first two layers of glass cloth. J Thoroughly saturate smallest glass cloth with putty-like cement and place it over screen. TA57370 4-20.3 Change 2 TM 9-2350-267-34

Privacy Statement
Press Release
Contact